ÿØÿàJFIFÿþ ÿÛC       ÿÛC ÿÀÿÄÿÄ"#QrÿÄÿÄ&1!A"2qQaáÿÚ ?Øy,æ/3JæݹÈ߲؋5êXw²±ÉyˆR”¾I0ó2—PI¾IÌÚiMö¯–þrìN&"KgX:Šíµ•nTJnLK„…@!‰-ý ùúmë;ºgµŒ&ó±hw’¯Õ@”Ü— 9ñ-ë.²1<yà‚¹ïQÐU„ہ?.’¦èûbß±©Ö«Âw*VŒ) `$‰bØԟ’ëXÖ-ËTÜíGÚ3ð«g Ÿ§¯—Jx„–’U/ÂÅv_s(Hÿ@TñJÑãõçn­‚!ÈgfbÓc­:él[ðQe 9ÀPLbÃãCµm[5¿ç'ªjglå‡Ûí_§Úõl-;"PkÞÞÁQâ¼_Ñ^¢SŸx?"¸¦ùY騐ÒOÈ q’`~~ÚtËU¹CڒêV  I1Áß_ÿÙ" Vim syntax support file " Maintainer: Bram Moolenaar " Last Change: 2001 Sep 04 " This file is used for ":syntax on". " It installs the autocommands and starts highlighting for all buffers. if !has("syntax") finish endif " If Syntax highlighting appears to be on already, turn it off first, so that " any leftovers are cleared. if exists("syntax_on") || exists("syntax_manual") so :p:h/nosyntax.vim endif " Load the Syntax autocommands and set the default methods for highlighting. runtime syntax/synload.vim " Load the FileType autocommands if not done yet. if exists("did_load_filetypes") let s:did_ft = 1 else filetype on let s:did_ft = 0 endif " Set up the connection between FileType and Syntax autocommands. " This makes the syntax automatically set when the file type is detected. augroup syntaxset au! FileType * exe "set syntax=" . expand("") augroup END " Execute the syntax autocommands for the each buffer. " If the filetype wasn't detected yet, do that now. " Always do the syntaxset autocommands, for buffers where the 'filetype' " already was set manually (e.g., help buffers). doautoall syntaxset FileType if !s:did_ft doautoall filetypedetect BufRead endif